58 LS9-16/32 Owner’s Manual
8To switch the phase of each channel
between normal and reverse phase, move
the cursor to the ø button of the desired
channel in the window, and press the
[ENTER] key.
The ø button will change from black to red, and the
phase of the corresponding channel will be reversed.
9If you want to operate the HA of a channel
that is not currently shown in the popup
window, use the [SEL] key to select that
channel, and then make settings for it.
For example if INPUT channels 1–8 are shown in the
popup window, pressing the INPUT channel 9 [SEL]
key will change the popup window to INPUT channels
9–16.
10
When you’ve finished making settings,
move the cursor to the CLOSE button (or
the × symbol in the upper right of the win-
dow) and press the [ENTER] key.
Here we will explain how to send the signal of an input channel to the STEREO bus or MONO
bus.
The STEREO bus / MONO bus are used to output signals to the main speakers. Signals can be
sent to the STEREO bus or MONO bus in either ST/MONO mode or LCR mode, and you can
choose either of these two modes for each channel. These two modes differ as follows.

ST/MONO mode • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

In this mode, signals are sent independently from the input channel to the STEREO bus and to the MONO bus.
• The signals sent from the same input channel to the STEREO bus and to the MONO bus can be switched on/
off independently.
• The panning of the signal sent from an INPUT channel to the STEREO bus L/R can be operated by the
SELECTED CHANNEL section [PAN] encoder, or by the TO ST PAN knob in the screen. (The signal sent to
the MONO bus is not affected by this encoder or knob.)
The volume balance of the signal sent from a ST IN channel to the STEREO bus left and right can be operated
by the SELECTED CHANNEL section [PAN] encoder, or by the TO ST BALANCE knob in the screen. (The
signal sent to the MONO bus is not affected by this knob.)

LCR mode • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

In this mode, the signal from the input channel is sent to three buses at once; STEREO (L/R) and MONO (C).
• The signals sent from the same input channel to the STEREO bus and to the MONO bus can be switched on/
off together.
• The CSR (Center Side Ratio) knob in the screen adjusts the proportion of the signal level sent from the input
channel to the STEREO (L/R) bus and the level sent to the MONO (C) bus.
• The level of the signal sent from the input channel to the STEREO (L/R) bus and the MONO (C) bus will
change according to the settings of the SELECTED CHANNEL section [PAN] encoder or the TO ST PAN
knob / TO ST BALANCE knob in the screen.
Sending the signal from an input channel to the STEREO/MONO bus
• If you want to use headphones etc. to monitor the signal of the STEREO bus or MONO bus, you should
press the DISPLAY ACCESS section [MONITOR] key several times to access the MONITOR screen, and
select “LCR” as the monitor source (
p. 146).
HINT
HA (head amp) settings • Sending the signal from an input channel to the STEREO/MONO bus