71
Sending signals from MIX channels to the STEREO/MONO bus
6
Output channel operations
LS9-16/32 Owner’s Manual
This section explains how to send the signal of a MIX channel to the STEREO bus or MONO
bus.
Signals can be sent to the STEREO bus or MONO bus in either ST/MONO mode or LCR mode,
and you can choose either of these two modes for each MIX channel. These two modes differ as
follows.

■ST/MONO mode• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

This mode sends the signal from the MIX channel to the STEREO bus and to the MONO bus independently.
•The signals sent from the same MIX channel to the STEREO bus and to the MONO bus can be switched on/off
individually.
• The panning of the signal sent from a monaural MIX channel to the STEREO bus L/R can be operated by the
SELECTED CHANNEL section [PAN] encoder, or by the TO ST PAN knob in the screen. (The signal sent to
the MONO bus is not affected by this encoder or knob.)
• The volume balance of the signals sent from two stereo-assigned MIX channels to the STEREO bus left and
right can be operated by the SELECTED CHANNEL section [PAN] encoder, or by the TO ST BAL knob in
the screen. (The signal sent to the MONO bus is not affected by this knob.)

■LCR mode • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

This mode sends the signal of the MIX channel to a total of three buses (STEREO (L/R) and MONO (C)) together.
•The signals sent from the same MIX channel to the STEREO bus and to the MONO bus can be switched on/off
together.
• The CSR (Center Side Ratio) knob in the screen adjusts the proportion of the signal level sent from the MIX
channel to the STEREO (L/R) bus and the level sent to the MONO (C) bus.
• The level of the signal sent from the MIX channel to the STEREO (L/R) bus and the MONO (C) bus will
change according to the settings of the SELECTED CHANNEL section [PAN] encoder or the TO ST PAN
knob / TO ST BAL knob in the screen.
1Press the SELECTED CHANNEL section
[HOME] key.
The SELECTED CH VIEW screen will appear in the
display.
1TO ST field
BTO ST PAN knob (for a stereo MIX channel,
the TO ST BAL knob)
2In the LAYER section, press the LAYER
[MASTER] key to select the master fader
layer.
3Press a [SEL] key in the channel module
section to select the send-source MIX chan-
nel.
4If you only want to adjust the pan or bal-
ance of the MIX channel, operate the
SELECTED CHANNEL section [PAN]
encoder (→ p. 86).
You can obtain the same result by moving the cursor to
the PAN/BAL knob in the SELECTED CH VIEW
screen and operating the dial or the [DEC]/[INC] keys.
Sending signals from MIX channels to the STEREO/MONO bus
• If you want to use headphones etc. to monitor the signal of the STEREO bus or MONO bus, you should
press the DISPLAY ACCESS section [MONITOR] key several times to access the MONITOR (2/4) screen,
and select “LCR” as the monitor source (
→
p. 146) before you continue with the following procedure.
HINT
1 2