Top panel
Panels and controls
19
M7CL Owner’s Manual
2
If an optional MBM7CL meter bridge is installed, the
MIX/MATRIX channel levels can be monitored at all
times. The monitoring position can be selected from PRE
EQ (immediately before attenuator), PRE FADER (imme-
diately before the fader), or POST ON (immediately after
the [ON] key).
1
MIX meters
These indicate the level of MIX channels 1–16.
B
MATRIX meters
These indicate the level of MATRIX channels 1–8.
In this section you can control the mix parameters for the
currently selected input channel or output channel.
1
[MIX/MATRIX] encoders
●
When an input channel is selected
This adjusts the send level of the signal sent from that
channel to the MIX/MATRIX buses.
●
When a MIX/STEREO/MONO channel is
selected
This adjusts the send level of the signal sent from the
selected MIX/STEREO/MONO channel to the
MATRIX buses.
●
When a MATRIX channel is selected
This adjusts the send level of the signal sent from each
MIX channel to the selected MATRIX bus.
●
When SENDS ON FADER mode
Push in an encoder to select the corresponding destina-
tion bus.
B
[HA] encoder
Adjusts the head amp gain of an input channel. This does
nothing if another type of channel is selected.
C
[PAN] encoder
●
When an input channel is selected
This adjusts the panning of the signal that is sent from
the selected channel to the L/R channels (or L/C/R
channels) of the STEREO bus.
●
When a ST IN channel is selected
This adjusts the left/right balance of the signals that
are sent from the selected two channels to the STE-
REO bus.
●
When a MIX channel (MONO x 2) is selected
This adjusts the panning of the signal that is sent from
the selected channel to the L/R channels of the STE-
REO bus.
●
When a MIX channel (STEREO) is selected
This adjusts the left/right balance of signals that are
sent from the two selected channels to the L/R chan-
nels of the STEREO bus or the left/right balance of the
output signals.
●
When a MATRIX channel (MONO x 2) is
selected
This encoder will be disabled.
●
When a MATRIX channel (STEREO) is selected
This adjusts the left/right balance of signals that are
output from the two selected channels.
●
When a STEREO channel is selected
This adjusts the left/right balance of the signals that
are output from the L/R channels of the STEREO bus.
■Meter bridge (option)
1 2
■SELECTED CHANNEL section
4
5
6
7
1 23
•If the SIGNAL TYPE of the destination bus is set to STEREO,
use the left encoders to adjust PAN and the right encoders to
adjust the send level.
NOTE
• The PAD will be internally switched on or off when the HA gain is
adjusted between -14 dB and -13 dB. Keep in mind that noise may
be generated if there is a difference between the Hot and Cold
output impedance of the external device connected to the INPUT
connector when using phantom power.
NOTE
•You can link this setting to the PAN setting for signals sent to
a MIX or MATRIX for which the BUS TYPE is set to STEREO.
(
→
p. 234)
NOTE