Sending the signal from an input channel to the MATRIX buses
M7CL Owner’s Manual
Input channel operations
5
75
DPRE button
This button selects the location from which the signal
of the input channel will be sent to the MATRIX bus.
The signal will be sent from POST (Immediately after
the [ON] key) if this button is off. The signal will be
sent from the PRE EQ (Immediately before the attenu-
ator) or PRE FADER (Immediately before the fader)
as specified in the BUS SETUP popup window if this
button is on.
ETO MATRIX SEND ON/OFF button
These are on/off switches for the signal sent from the
input channels to the MATRIX bus.
FTO MATRIX SEND LEVEL knob
This screen shows the send level of the signal sent
from the input channels to the MATRIX bus. To adjust
the level, operate multifunction encoders 1–8.
If the send-destination MATRIX bus is set to stereo,
the TO MATRIX PAN knob (for a ST IN channel, the
TO MATRIX BALANCE knob) and TO MATRIX
SEND LEVEL knob are shown in this location.
GALL PRE button
This button selects PRE as the position from which
signals are sent from all input channels to MATRIX
buses.
HALL POST button
This button selects POST as the position from which
signals are sent from all input channels to MATRIX
buses.
6Use the TO MATRIX SEND ON/OFF buttons
to switch the signals sent from the input
channels to the currently selected MATRIX
bus on/off.
7If necessary, use the PRE buttons to select
the location of the signal that is sent from
each input channel to a MATRIX bus.
8Repeat steps 3–6 to adjust the send level
for other MATRIX buses in the same way.
Here’s how you can use the faders on the top panel to
adjust the signal that is sent from all input channels to a
specific MATRIX bus.
1Make sure that an output port is assigned
to each MATRIX bus to which you want to
send signals, and that your monitor system
or external effect etc. is connected to the
corresponding output port.
For details on assigning an output port to a MATRIX
bus refer to p. 105. For details on connecting an exter-
nal device, refer to p. 46.
2In the function access area, press the
SENDS ON FADER button.
The M7CL will switch to SENDS ON FADER mode.
The most recently selected group of MIX/MATRIX
buses will be assigned to the Centralogic section. The
faders in the INPUT section and ST IN section will
move to reflect the send level of the signals that are
routed from each channel to the currently-selected
MIX/MATRIX buses.
In SENDS ON FADER mode, the function access area
in the display will show the button that enable you to
switch between MIX ON FADER mode and MATRIX
ON FADER mode, and the buttons that enable you to
select the destination MIX/MATRIX buses.
1MIX/MTRX ON FADER switch button
Pressing this button repeatedly will toggle between
MIX ON FADER mode and MATRIX ON FADER
mode.
BMIX/MATRIX bus selection buttons
These buttons enable you to select the destination
MIX/MATRIX buses. Only one button will appear if
two buses are paired as stereo.
3Press the MIX/MTRX ON FADER switch but-
ton to select MATRIX ON FADER mode.
In this way, you can use the MIX/MATRIX bus selec-
tion buttons to specify the destination MATRIX buses.

Using the faders (SENDS ON

FADER mode)

2
1