Operations in the Centralogic section
M7CL Owner’s Manual
Operations in the Centralogic section
8
103
●Adjusting the pan/balance (INPUT, ST IN,
STEREO, and MIX channels only)
In the OVERVIEW screen, you can use the TO STEREO/
MONO field to switch the on/off status and adjust the pan/
balance of the signal sent from each channel to the STE-
REO/MONO buses. The following items are shown in the
TO STEREO/MONO field.
1PAN/BALANCE knob
• When an INPUT channel or monaural MIX chan-
nel is selected
........The panning of the signal sent to the
STEREO bus is shown.
•When a ST IN channel or a stereo MIX channel is
selected
........The balance of the left/right signals sent
to the STEREO bus is shown and adjust
the output balance to the STEREO bus.
• When a STEREO channel or a stereo MATRIX
channel is selected
........The balance of the left/right output sig-
nals is shown.
To adjust the value, press the knob to select it, and
operate multifunction encoders 1–8.
If you press the selected knob once again, the TO
STEREO/MONO popup window (8 ch) will appear. In
this popup window, you can switch between ST/
MONO mode and LCR mode, and change the on/off
status of the signal sent to the STEREO/MONO bus
for up to eight channels at a time. (For details on the
popup window → p. 63).
BOVER indicator
This indicator will light if any of the level detection
points in each channel reach the OVER level.
CST/MONO indicator (INPUT, ST IN, and
MIX channels only)
This indicates the on/off status of the signal sent from
that channel to the STEREO (L/R) bus and MONO
(C) bus. To switch this on/off, press the selected knob
once again to open the TO STEREO/MONO popup
window.
If an INPUT, ST IN, or MIX channel is set to LCR mode,
the C area will change as follows.
DLCR indicator (INPUT, ST IN, MIX chan-
nels only)
The LCR indicator shows the overall on/off status of
the signals sent from that channel to the STEREO (L/
R) bus and MONO (C) bus.
To switch this on/off, press the selected knob once
again to open the TO STEREO/MONO popup win-
dow.
●Assigning a channel to a DCA group or Mute
group
In the OVERVIEW screen, you can use the DCA/MUTE
GROUP field to assign a channel to a DCA group (input
channels only) or mute group. This field includes the fol-
lowing items.
1DCA indicator (input channels only)
This indicator shows the DCA group(s) to which the
input channel is assigned. The numbers of DCA
groups to which this channel belongs are highlighted.
BMute indicator
This indicator shows the mute groups to which the
channel is assigned. The numbers of mute groups to
which this channel belongs are highlighted.
To assign a channel to a DCA group or Mute group, press
the DCA/MUTE GROUP field to open the DCA/MUTE
GROUP ASSIGN popup window. (For details on the
popup window → p. 124).
1 2 3
4
1
2