166 MIDI
02R User’s Guide
Configuring Remotes
MIDI Remote operations take place on the MIDI 5/5 page shown below.
Up to four remotes can be active at the same time, each operating on a
different MIDI Channel. The REMOTE 1 to 4 icons are used to select the
remotes.
On the page shown below, the Programmable Mixer 01 configuration has
been selected for use with REMOTE 1. The same configuration can be
selected for use with several remotes. So you could, for example, control
two or three 02Rs remotely.
While the MIDI 5/5 page is selected, the following controls have no effect
on the 02R (essentially these control are in a local off condition): 02R faders,
rotary encoders, [ON] buttons, MIC/LINE [SEL] buttons 1 to 16, CURSOR
buttons, and encoder wheel. To remind you of this the message “>>>>
REMOTE <<<<“ flashes at the bottom of the MIDI 5/5 page.
The various remote configurations are explained on the following pages.
1. Use the [MIDI] button to
locate the MIDI 5/5
page.
The [FLIP] button flashes.
To get to the MIDI 5/5
quickly, hold down the
[FLIP] button for about
one second.
2. Use the CURSOR buttons
to select a REMOTE icon,
and press the [ENTER]
button to activate it.
3. Use the CURSOR buttons
to select the rotary icon,
and the encoder wheel
to select a remote
configuration.
4. Use the CURSOR buttons
to select the MIDI CH
parameter, and the
encoder wheel to select
a MIDI Channel for the
remote.
Only MIDI Channels
other than the MIDI
Channels selected on
the MIDI 1/5 page can
be selected.
MIDI