252 Specifications
02R User’s Guide
Fixed Fragmentation! The automix memory has been corrected. Abnormal data may be
generated in the memory if you turn off the power during recording
or if incomplete bulk data is received.
Frame Drop Out!(#) Time code frame is dropping out.
(The count in the parenthesis shows the number of dropping
frames.)
Frame Jump! Time code frame is dropping out.
ID Mismatch! Model ID for parameter change is not correct.
Illegal Time Range! In/out time setting is incorrect.
Low Battery! The internal battery voltage is getting very low. Back up the setup data
stored in the 02R (see “Bulk Dump/Request” on page 161 of the

User’s

Guide

), and ask your dealer to replace the battery.
MAIN SCI0 Framing Err. Consult the nearest YAMAHA service center.
MAIN SCI0 OverRun Err. Consult the nearest YAMAHA service center.
MAIN SCI0 Party Err. Consult the nearest YAMAHA service center.
MAIN SCI0 RxBuf. Full MIDI data being transmitted is too large.
MAIN SCI0 TxBuf. Full MIDI data being received is too large.
MAIN SCI1 Framing Err. Check the connection at the TO HOST connector.
MAIN SCI1 OverRun Err. Check the connection at the TO HOST connector.
MAIN SCI1 Party Err. Check the connection at the TO HOST connector.
MAIN SCI1 RxBuf. Full Check the connection at the TO HOST connector.
MAIN SCI1 TxBuf. Full Check the connection at the TO HOST connector.
MAIN->SUB Disconnected! Consult the nearest YAMAHA service center.
Make New Mix! First make a New Mix.
Memory Full! Automix memory is full.
MIDI Ch Mismatch (#) The device number of the received bulk data is not correct.
No Aux Send! There is no AUX send from EFF1 to AUX7 or EFF2 to AUX8.
No Time Code! Time code is not being input.
Preset is read only! You cannot store data to the preset memory.
Redone. The previous operation was redone.
Scene 0 is read only! You cannot store data to Scene “0.”
Scene Memory Protected! Scene memory is write-protected.
Select Channel! A channel for extract has not been assigned.
Select Parameter! The parameter for extract has not been assigned.
Set Overwrite! Set the overwrite parameter.
SOLO Ready! The track is ready for solo.
SOLO Slave! You cannot change the solo status and the Solo key is disabled if the
unit is a cascade slave.
SUB->MAIN Disconnected! Consult the nearest YAMAHA service center.
SUB SCI0 Framing Err. Consult the nearest YAMAHA service center.
SUB SCI0 OverRun Err. Consult the nearest YAMAHA service center.
Error Message Corrective Action