228 Installing Options
02R User’s Guide
Wordclock Selection
1. Power on your ADAT modular digital multitrack recorder and then
the 02R.
It is always important to observe the correct order for powering up
equipment in a studio. Start with the ADAT and mastering recorders
and the signal processors, then the 02R, and finally the monitoring
amplifiers and other downstream gear.
2. Use the [DIGITAL I/O] button to locate the DIGITAL I/O 1/5 page.
If the card was installed properly, the 02R will identify it in the
appropriate slot. The ADAT digital I/O card (CD8-AT) can be installed
in any slot. You should install the first two cards in SLOT1 and SLOT2
in order to access the direct out lines.
3. Use the CURSOR buttons to select the wordclock source.
If you are using the 48kHz OUT connector from the BRC ADAT remote
controller plugged into the WORD CLOCK—IN connector, use the
CURSOR buttons to select the W.CLK IN box and press the [ENTER]
button. If you are just using an ADAT modular digital multitrack
recorder, select the TAPE 1/2 box—the first box in the SLOT1
row—and press the [ENTER] button.
The current wordclock source is indicated by a highlighted icon. See
“Word Clock Select” on page 188 of the User’s Guide for further details.
Note: If the W.CLK IN box or the TAPE1/2 box is not showing a proper
wordclock input (no discrepancy between the input and selected wordclock
frequencies), check the connections between the ADAT modular digital
multitrack recorder and the 02R.Check that the ADAT recorder is powered
on.