Yamaha O2R 74 Mixing and Automix, Automix Recording Notes

74 Mixing and Automix
02R Getting Started Guide
begin. The timecode will be displayed in real-time in the “Time Code” field
of the “Automix Main” page.
5. While monitoring the recording, operate the faders and other
controls for the selected channels.
When you are recording the automix events, you can only operate the
controls, specifically the faders, of the selected channels.
Note: If the timecode is not being displayed correctly in the “Time Code” field,
check the following:
•Are your cables connected between the timecode source device and the 02R
correctly?
•Is the timecode source device setup correctly to output timecode?
Note: The 02R tries to prevent accidental level changes by “freezing” the faders
that have not been selected. To avoid damaging the unit, do not attempt to operate
the faders of channels that have not been selected.
Automix Recording Notes
• When you are recording pan or EQ changes you may find it more
convenient to use the buttons and controls of the SELECTED
CHANNEL block.
• If you have selected more than one channel with the [SEL] buttons, the
SELECTED CHANNEL controls can only adjust the channel that was
selected last. The same applies for EQ and dynamics processor
operations. Because of these restrictions, you may find it more
convenient to work on your automix recording one channel at a time
when editing EQ and pan data.
• While you are recording automix events, you can select other 02R
display functions, allowing you to adjust the parameters for multiple
channels.
• To record a recall operation from EQ, dynamics, or channel libraries,
press the [SEL] button for the channel to be changed, then use the
corresponding display function to perform the recall operation. To
record a recall operation from the effect libraries, use the [AUX 7] or
[AUX 8] button to access the effect libraries.