206 Digital I/O, Setup, and Utilities

02R User’s Guide
Input Patching
The Input Patching function allows you to select the signal sources for
MIC/LINE channels 1 to 24 and TAPE channels 1 to 16. The same source
can be selected for several channels. Bus outs can be patched through to the
TAPE channels for bus out monitoring and subgrouping. To prevent a
feedback loop, you cannot select bus outs to which a channel is routed, or
route a channel to the bus selected as its signal source. In either case a
warning message appears.
Shown below is the TAPE 1–8 page of SCENE 4/5. On this page you can
select a card input from 1 to 8 or the corresponding bus out for TAPE
channels 1 to 8.
Shown below is the TAPE 9–16 page of SCENE 4/5. On this page you can
select a card input from 9 to 16 or the corresponding bus out for TAPE
channels 9 to 16.
In 24bit MODE you cannot select individual
buses. If you attempt to select a bus, the
confirmation dialog box shown here appears.
Choose EXECUTE to assign all buses to the card
inputs.
1. Use the [SCENE
MEMORY] button to
locate the SCENE 4/5
page.
2. Use the CURSOR buttons
to select an input icon,
and the (ENTER) button
to select that input
channel group.
You can also use the
[SEL] buttons to select
input channel groups.
3. Use the CURSOR buttons
to select a signal source,
and the (ENTER) button
to set it.
SCENE
MEMORY