CONNECTIONS
Connecting the antennas
Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals.
AM loop antenna | Indoor FM antenna |
(included) | (included) |
White | Black |
AM ANT GND | FM ANT |
TUNER | 75Ω UNBAL |
|
Ground (GND terminal)
For minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth.
■Connecting the AM loop antenna
1Set up the AM loop antenna, then connect it to the terminals on this unit.
2Lift up the tab and insert the white cord into the AM ANT terminal and the black cord into the GND terminal.
Tab
AM ANT | GND terminal | |
terminal | ||
|
Cable wires
Cable wires
Black
White
3Orient the AM loop antenna for the best reception.
Notes
•The AM loop antenna should be placed away from this unit and all speaker cords.
•The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.
•A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may improve the quality. Consult the nearest authorized YAMAHA dealer or service center about outdoor antennas.
■Frequency Step (Asia and General
models only)
Because the interstation frequency spacing differs in different areas, set the FREQUENCY STEP (using SET MENU) according to the frequency spacing in your area (see page 45).
•North, Central and South America: 100 kHz/10 kHz
•Other areas: 50 kHz/9 kHz
14