Yamaha RX-SL80 owner manual Remote control, Problem, Cause, Remedy, Refer to

TROUBLESHOOTING

	The desired station	The signal is weak or the antenna	Tighten the AM loop antenna connections	—
	cannot be tuned in with	connections are loose.	and orient it for best reception.
	the automatic tuning
			Use the manual tuning method.	23
	method.
	There are continuous	Noises result from lightning,	Use an outdoor antenna and a ground wire.	—
	crackling and hissing	fluorescent lamps, motors,	This will help somewhat, but it is difficult to
	noises.	thermostats and other electrical	eliminate all noise.
AM		equipment.
	There are buzzing and	A TV set is being used nearby.	Move this unit away from the TV.	—
	whining noises
		The AM loop antenna is placed near	Place the AM loop antenna away from the	—
	(especially in the
	evening).	the speaker cables.	speaker cables.
		The AM ANT and GND cords are	Make sure the white cord is inserted into the	14
		inserted in the wrong terminal.	AM ANT terminal and the black cord into
			the GND terminal.

■Remote control

Problem	Cause	Remedy	Refer to
			page
The remote control	Wrong distance or angle.	The remote control will function within a maximum	6
does not work or		range of 6 m (20 ft) and no more than 30 degrees off-
function properly.		axis from the front panel.
	Direct sunlight or lighting (from an	Reposition this unit.	—
	inverter type of fluorescent lamp, etc.) is
	striking the remote control sensor of this
	unit.
	The batteries are weak.	Replace all batteries.	3
	The remote control code was not correctly	Set the remote control code correctly.	47
	set.
		Try to set the other codes of the same manufacturer.	47
	Even if the remote control code is
	correctly set, some models may not
	respond to the remote control.

54