SPEAKER SETUP
■IMPEDANCE SELECTOR switch
CAUTION
Do not change the setting of the IMPEDANCE SELECTOR switch when the unit power is switched on, as doing so may damage the unit.
If this unit fails to turn on when STANDBY/ON is pressed on either the front panel or remote control, the IMPEDANCE SELECTOR switch may not be fully slid to either position. If this is the case, slide the switch all the way to either position when this unit is in standby mode. Be sure to move this switch only when this unit is in standby mode.
Select the switch position (top or bottom) according to the impedance of the speakers in your system.
MAINS
IMPEDANCE SELECTOR switch
Switch | Speaker | Impedance level | ||
position | ||||
|
|
| ||
|
|
|
| |
| Front | The impedance of each speaker | ||
Top |
| |||
| must be 4 | Ω or higher. | ||
Center, Surround | ||||
| ||||
|
|
| ||
|
|
|
| |
| Front | The impedance of each speaker | ||
Bottom |
| |||
| must be 6 | Ω or higher. | ||
Center, Surround | ||||
| ||||
|
|
| ||
|
|
|
| |
10
