Speaker connections
Be sure to connect the left channel (L), right channel (R), “+” (colored) and
CAUTION
•If you will use 6 ohm speakers, be sure to set this unit’s speaker impedance setting to 6 ohms before using (see “IMPEDANCE SELECTOR switch” on page 10).
•Before connecting the speakers, make sure that the power of this unit is off.
•Do not let the bare speaker wires touch each other or do not let them touch any metal part of this unit. This could damage this unit and/or speakers.
•Use magnetically shielded speakers. If this type of speakers still creates the interference with the monitor, place the speakers away from the monitor.
A speaker cord is actually a pair of insulated cables running side by side. One cable is colored or shaped differently, perhaps with a stripe, groove or ridges.
Connect the striped (grooved, etc.) cable to the “+” (colored) terminals on this unit and your speaker. Connect the plain cable to the
10 mm (3/8")
1 |
|
|
| 2 |
1Remove approximately 10 mm (3/8") of insulation from each of the speaker cables.
2Twist the exposed wires of the cable together to prevent short circuits.
3Press and hold the tab to insert the speaker wire.
SPEAKER SETUP
4Return the tab to secure the wire.
Colored: positive (+)
Black: negative
■Cable tags
5 pairs of different colored cable tags are provided with this product. The colors of the cable tags and their respective speaker cables are as follows:
•Red: Front right speaker cable
•White: Front left speaker cable
•Green: Center speaker cable
•Gray: Surround right speaker cable
•Blue: Surround left speaker cable
To make it easier to distinguish the various speaker cables, attach the colored tags to the appropriate speaker cables as shown below.
PREPARATION
English
9
