Rear panel
L MIDI connectors
These are standard
●MIDI IN connector
MIDI data is received at this connector. Use a MIDI cable to connect this to the MIDI OUT connector of your external MIDI device.
●MIDI OUT connector
MIDI data is transmitted from this connector. Use a MIDI cable to connect this to the MIDI IN connector of your external MIDI device.
●MIDI THRU connector
Data received at the MIDI IN connector is
For example if you have connected three M2500 units via MIDI as shown below, switching scenes on the master M2500 (1) can cause the slave M2500 units (2/3) to switch scenes in the same way.
MIDI OUT | MIDI IN | MIDI THRU | MIDI IN |
M2500M2500M2500
1 2 3
PHANTOM
MASTER
OFF 
ON 
M
N
READ OWNER’S MANUAL DC POWER INPUT
M PHANTOM MASTER switch
This is the master switch for the +48 V phantom power supply.
N DC POWER INPUT connector
Connect the supplied PW3000MA power supply to this connector to supply power to the M2500.
Note: The PW3000M power supply cannot be used with the M2500 mixer.
Note: Before connecting or disconnecting the power supply cable, make sure that the power of the PW3000MA is turned off.
By connecting two PW3000MA units to the M2500 as shown in the following diagram, you can ensure a stable supply of power. In this case, each PW3000MA will supply 50% of the power to the M2500. In the unlikely event that one of the PW3000MA units fail, the other PW3000MA will automatically supply 100% of the power to the M2500.
M2500
DC POWER INPUT
DC POWER INPUT
DC PARALLEL INPUT | DC OUTPUT |
PW3000MA
DC PARALLEL INPUT | DC OUTPUT |
DC OUTPUT
PW3000MA
DC PARALLEL INPUT | DC OUTPUT |
O
LAMP
O LAMP connector
This is an
