Zebra Technologies S-300 manual Communications

Getting Started

Communications

The Stripe comes with either an Electronics Industries Association (EIA) RS-232 serial data interface or a factory-installed parallel interface. In both cases, you must supply the required interface cable for your application. See the Appendix for specific cable requirements.

CAUTION: Zebra printers comply with FCC “ Rules and Regulations” , Part 15, Subpart J, for Class A Equipment, using fully shielded six-foot data cables. Use of longer cables or unshielded cables may increase radiated emissions above the Class A limits.

Cutter Module Interface (For Stripes with the Factory-Installed Cutter Option)

The Cutter Module connects to the printer via a standard 8-pin connector.

The cable on the front of the printer plugs into the connector on the bottom of the Cutter Module once the Cutter Module has been installed.

4