Press | Display Shows | Action/Explanation |
|
| Setting Print Width: Press the RIGHT BLACK OVAL key to |
|
| increase the value, press the LEFT BLACK OVAL key to |
|
| decrease the value. To change the unit of measurement, press |
|
| the LEFT BLACK OVAL key until the unit of measurement is |
|
| active, then press the RIGHT BLACK OVAL key to toggle to a |
| PRINT WIDTH | different unit of measure (mm, inches, or dots). |
|
| Default; Range: The default and range of acceptable values |
|
| vary depending on what printer you have. Refer to “Printing |
|
| Specifications” on page 90 for further information about the |
|
| ranges available for your model. Print width determines the |
|
| printable area across the width of the label. |
|
| NOTE: The printer does not accept any value larger than the |
|
| maximum print width listed on page 90. |
|
|
|
|
| Setting Maximum Length: Press the LEFT BLACK OVAL key to |
|
| decrease the value, press the RIGHT BLACK OVAL key to |
|
| increase the value. |
|
| Default; Range: The default and range of acceptable values |
|
| vary depending on your printer’s configuration. Values are |
| MAXIMUM LENGTH | adjustable in 1" (25.4 mm) increments. |
|
| Maximum length is used in conjunction with the calibration |
|
| procedure. The value of this setting is the maximum label length |
|
| that is used during the media portion of the calibration process. |
|
| Only a few labels are required to set media sensors. Always set |
|
| the value that is at least 1" longer than the longest label to be |
|
| used on the printer. |
|
|
|
46 | Zebra |