The media, ribbon, and label available sensors should be cleaned on a regular basis to ensure proper operation of the printer. To locate these sensors, refer to Figure 27 on page 65, Figure 6 on page 11, and Figure 7 on page 12. Brush/vacuum any accumulated paper lint and dust off of these sensors.
&OHDQLQJWKH6QDS3ODWHClean the snap plate to remove label adhesive or a label that has adhered to the underside of the snap plate.
Refer to Figure 28.
1.Insert a
2.Repeat step one on the right side of the snap plate.
3.Remove the snap plate from the printer.
4.Clean the snap plate with cleaning solvent and a soft cloth. Refer to Figure 29.
5.To reinstall the snap plate, insert the two tabs on the bottom of the snap plate into the two slots of the media pathway.
6.Slide the snap plate toward you.
7.Press down on the loops to lock the snap plate into place.
Zebra | 69 |