Color profile: Disabled

Composite Default screen

Media and Ribbon Sensor Profile

The Media and Ribbon Sensor Profile may be used to troubleshoot registration problems that may be caused when the Media Sensor experiences difficulty in determining web location between labels.

To print a Media and Ribbon Sensor Profile, you must press and hold the PAUSE key, FEED key, and CANCEL key while turning the printer power ON. Release all three keys anytime after the first front panel LED turns OFF. Figure 24 provides an example of the Media and Ribbon Sensor Profile sample printout.

Figure 24. Media & Ribbon Sensor Profile

Resetting Factory Defaults

From time to time, it may be necessary to return the printer configuration to a "known" state. A set of Factory Defaults can be loaded into the printer as a starting point from which one can then reconfigure the printer for the application desired.

To reset Factory Defaults, press and hold both the PAUSE and FEED keys while turning the printer power ON. Release both keys anytime after the first front panel LED turns OFF. Once the Power-On Self Test is completed, open the printer's front panel door and press the Print Darkness Key two times to save the Factory Defaults parameters in EEPROM memory. To signify that the parameters have been saved, all three Control LEDs will flash on then off.

(An alternate method of setting Factory Defaults is by sending the ZPL commands “^JUF^JUS” to the printer.) In addition, for printers with the deluxe front panel, factory default settings may be saved through the LCD configuration.

As of Firmware Release V22.8.4, this process no longer initializes the optional on-board flash menory device nor the optional PCMCIA Card.

46

Z Series™ User’s Guide

54

H:...uspiran2.vp

Thu Jun 18 16:02:08 1998