Color profile: Disabled Composite Default screen

ON

OFFDIP SwitchPositions

Refer to Table 8 if the settings need to be changed to match those of your host computer. If you do not know the settings of your host com- puter, refer to the instruction manual provided with the computer.

The serial port supports an Error Detection Protocol which sends and receives data in packets. This “Zebra” protocol must be compatible with your host computer and your application software. Received packets are checked for accuracy. If received correctly, the data in the packet is processed and an “acknowledge” packet is sent back to the host. If an error is found in the received packet, either a “negative acknowledge” packet or no response will be sent to the host. DO NOT enable Error Detection unless your host is programmed to use it. For additional information, refer to the ZPL II Programming Guide.

If the Bank One switches are in the proper position to match the communication configuration of the host computer, and the printer is not receiving data, see Appendix B to make sure you are using the correct interface cable.

BAUD RATE

SWITCH 1

SWITCH 2

SWITCH 3

9600

ON

ON

ON

19200

OFF

ON

ON

28800

ON

OFF

ON

38400

OFF

OFF

ON

600

ON

ON

OFF

1200

OFF

ON

OFF

2400

ON

OFF

OFF

4800

OFF

OFF

OFF

 

 

 

 

DATA BITS

SWITCH 4

NOTE: The printer requires one (1)

8 Data Bits

ON

stop bit minimum on received data

7 Data Bits

OFF

and automatically supplies two (2)

stop bits for transmitted data.

 

 

 

 

 

 

HANDSHAKE

SWITCH 5

 

 

Xon/Xoff

ON

 

 

DTR/DSR

OFF

 

 

 

 

 

 

PARITY

SWITCH 6

SWITCH 7

 

Parity Disabled

ON

ON

 

Even

OFF

ON

 

Odd

ON

OFF

 

Parity Disabled

OFF

OFF

 

 

 

 

 

ERROR DETECTION

SWITCH 8

NOTE: Zebra Protocol is the default

 

 

Off

ON

Error Detection Protocol enabled

On

OFF

when “On - Switch 8 OFF” is selected.

 

 

Table 8. Bank 1 Switch Settings

58

Z Series™ User’s Guide

 

66

H:...uspiran2.vp

 

Thu Jun 18 16:03:33 1998