Zonet Technology ZSR0104C Series user manual For Unix/Linux

5. For Unix/Linux

If you use Unix or Linux, follow the steps to verify the IP settings in your client PC.

Step 1. To release the previous IP settings of your computer, run the command “kill all dhcpcd”.

Step 2. To obtain new IP settings from ZSR0104C SERIES, run the command “dhcpcd eth#”. “#” Means the number of the Ethernet Network Interface Card installed in your client computer.

Step 3. To learn the new IP settings, please run the command “ipconfig eth#”. “#” Means the number of the Ethernet Network Interface Card installed in your client computer. It will show the IP address and Subnet Mask of your client PC. Then run the command “route –n”, the IP address of your Default Gateway will be displayed. It means your router’s IP address. Make sure that your IP address is 192.168.1.xxx (xxx ranges from 2 to 254), your Subnet Mask is 255.255.255.0, and your Default gateway is 192.168.1.1. These values confirm that your ZSR0104C SERIES is functioning.

Page 50