Zoom operation manual Preparations, Using Batteries, Turn power to the MRT-3 on

Preparations

Preparations

When connections are complete, set the volume as follows.

1.While the playback system is still turned off and the volume is fully turned down, double-check whether all connections have been made correctly.

If cables are connected or disconnected while power is on, or if power is turned on with the volume turned up, damage to the speakers may occur.

2. Turn power to the MRT-3 on.

Set the [POWER] switch to ON.

3.Turn power to the playback system on and set the volume to about midway.

4.While tapping a pad to produce sound,

adjust the [OUTPUT LEVEL] knob of the MRT-3 to obtain a suitable volume.

Using Batteries

The MRT-3 can be powered from batteries (not supplied). Follow the steps below to insert the batteries.

1.Turn the unit over and open the battery compartment cover.

2.Insert four fresh IEC R6 (size AA) batteries into the battery compartment. The use of

alkaline batteries is recommended.

3.Close the battery compartment cover.

NOTE

When using batteries, a flashing dot at the right side of the display means that the batteries are nearly exhausted. Insert fresh batteries as soon as possible.

MRT-3 underside

Four IEC R6 (size AA) batteries

8 ZOOM MRT-3