
Prestige 202H User’s Guide
Chapter 2
Hardware Installation
This chapter shows you how to make the cable connections to your router.
2.1Front Panel
The LED indicators on the front panel indicate the operational status of the router. The table after the diagram describes the LED functions:
| Figure |
| Table |
|
|
LED | DESCRIPTION |
|
|
PWR/SYS | The PWR/SYS (power/system) LED turns steady on green when power is applied to |
| the router and it has boot up properly. |
| A green blinking PWR/SYS LED indicates the router is performing a system test or |
| rebooting. |
| When the router senses low voltage power, the PWR/SYS LED turns steady on red. |
|
|
LAN | A steady green light indicates a successful 10Mbs Ethernet connection, while an |
| orange light indicates a successful 100Mbs connection. The LEDs will blink when |
| data is being sent/received. |
ISDN LNK, B1, B2 | The LNK LED is on when the router is connected to an ISDN switch and the line |
| has been successfully initialized. The B1 (B2) LED remains steady on when data is |
| being sent/received on the B1 (B2) bearer channel. |
Hardware Installation |