Prestige 202H User’s Guide

Table 10-2 Menu 13 Default Dial-in Setup

FIELD

DESCRIPTION

EXAMPLE

 

 

 

Dial-in User

If set to Yes, the Prestige will allow a remote host to specify its

Yes (default)

 

own IP address.

 

 

If set to No, the remote host must use the IP address assigned

 

 

by your Prestige from the IP pool, configured below. This is to

 

 

prevent the remote host from using an invalid IP address and

 

 

potentially disrupting the whole network.

 

 

 

 

IP Pool

This field tells your Prestige to provide the remote host with an IP

No (default)

 

address from the pool. This field is required if Dial-In IP Address

 

 

Supplied By: Dial-in User is set to No. You can configure this

 

 

field even if Dial-in User is set to Yes, in which case your

 

 

Prestige will accept the IP address if the remote peer specifies

 

 

one; otherwise, an IP address is assigned from the pool.

 

 

 

 

IP Start Addr

This field is applicable only if you selected Yes in the Dial-In IP

 

 

Address Supplied By: IP Pool field.

 

 

The IP pool contains contiguous IP addresses and this field

 

 

specifies the first one in the pool. The IP start address is the start

 

 

of a series of consecutive IP addresses.

 

IP Count (1, 2)

In this field, enter the number (1 or 2) of addresses in the IP

1

 

Pool. For example, if the starting address is 192.168.135.5 and

 

 

the count is 2, then the pool will have 192.68.135.5 and

 

 

192.68.135.6. The IP count is the number of consecutive IP

 

 

addresses allowed.

 

 

 

 

Session Options:

Press [SPACE BAR] and then [ENTER] to select Yes to edit the

 

Edit Filter Sets

filter sets. Keep in mind that the filter set(s) will only apply to

 

remote dial-in users but not the remote nodes.

 

 

No (default)

 

NOTE: Spaces and [–] symbol are accepted in this field. For

 

 

 

more information on customizing your filter sets, see Chapter 9

 

 

Filter Configuration. The default is blank, i.e., no filters.

 

Once you have completed filling in this menu, press [ENTER] at the message “Press ENTER to Confirm…” to save your configuration, or press [ESC] to cancel.

10.3.1 Default Dial-in Filter

Use Menu 13.1 – Default Dial-in Filter to specify the filter set(s) to apply to the incoming and outgoing traffic between all dial-in users and your Prestige. Note that the filter set(s) only applies to the dial-in users

10-4

Dial-in Setup