Prestige 202H User’s Guide

Menu 11.3 - Remote Node Network Layer Options

IP Options:

Rem IP Addr = 0.0.0.0

Rem Subnet Mask= 0.0.0.0

My WAN Addr= N/A

NAT= SUA Only

Address Mapping Set= N/A

Metric= 2

Private= No

RIP Direction= None

Version= RIP-1

Enter here to CONFIRM or ESC to CANCEL:

Figure 11-4 Applying NAT to the Remote NodeTable 11-3 Applying NAT to the Remote Node

FIELD

DESCRIPTION

EXAMPLE

 

 

 

NAT

Press [SPACE BAR] and then [ENTER] to select Full Feature if you

Full Feature

 

have multiple public WAN IP addresses for your Prestige. The SMT

 

 

uses the address mapping set that you configure and enter in the

 

 

Address Mapping Set field (menu 15.1 - see section 11.3.1). When

 

 

you select Full Feature you must configure at least one address

 

 

mapping set!

 

 

 

 

 

Select None to disable NAT.

 

 

 

 

 

When you select SUA Only, the SMT uses Address Mapping Set 255

 

 

(menu 15.1 - see section 11.3.1). Choose SUA Only if you have just

 

 

one public WAN IP address for your Prestige.

 

11.3 NAT Setup

Use the Address Mapping Sets menus and submenus to create the mapping table used to assign global addresses to computers on the LAN. You can see two NAT Address Mapping sets in menu 15.1. You can only configure Set 1. Set 255 is used for SUA. When you select Full Feature in menu 4 or 11.3, the SMT will use Set 1, which supports all mapping types as outlined in Table 11-2.When you select SUA Only, the SMT will use the pre-configured Set 255 (read only).

The Server Set is a list of LAN side servers mapped to external ports. To use this set (one set for the Prestige 10), a server rule must be set up inside the NAT Address Mapping set. Please see section 11.4 for further information on these menus. To configure NAT, enter 15 from the main menu to bring up the following screen.

Dial-in Setup

11-7