P782M G.SHDSL Bridge

2.2.3 LAN 10/100M Port

Ethernet 10Base-T/100Base-T networks use Shielded Twisted Pair (STP) cable with RJ-45 connectors that look like a bigger telephone plug with 8 pins. Use the crossover cable to connect your Prestige to a computer directly or use a straight-through Ethernet cable to connect to an external hub, then connect one end of the straight-through cable from the hub to the NIC on the computer.

When the Prestige is on and properly connected to a computer or a hub, the

corresponding LAN LED on the front panel turns on.

2.2.4 Power Port

Connect the power adapter to the port labeled POWER on the rear panel of your Prestige.

To avoid damage to the Prestige, make sure you use the correct power adapter.

Refer to the Power Adapter Specification Appendix for this information.

2.3Additional Installation Requirements

•An Ethernet 10/100Base-T NIC (Network Interface Card).

•Communications software configured as follows:

VT100 terminal emulation 9600 baud

parity set to none, 8 data bits, 1 stop bit flow control set to none

2.4Turning On Your Prestige

At this point, you should have connected the xDSL, LAN 10/100M, console and power ports to the appropriate devices. Make sure the power adapter is plugged into an appropriate power source and the power switch (located on the back of your Prestige) is “on” (or pressed).

2.5Configuring Your Prestige For Internet Access

Configure your Prestige for Internet access using:

SMT (System Management Terminal). Access the SMT via: o LAN or WAN using Telnet

Hardware Installation and Initial Setup