P782M G.SHDSL Bridge

Chapter 4

Remote Node Configuration

This chapter covers the parameters that are protocol-independent. The protocol-dependent configurations (TCP/IP and Bridging) are covered in the next chapters.

4.1Remote Node Setup

A remote node is required for placing calls to a remote gateway. A remote node represents both the remote gateway and the network behind it across a WAN connection. When you use menu 4 to set up Internet access, you are configuring one of the remote nodes.

This section describes the protocol-independent parameters for a remote node.

4.1.1 Remote Node Profile

To configure a remote node, follow these steps:

Step 1. From the main menu, enter 11 to display Menu 11 — Remote Node Setup.

Step 2. When menu 11 appears, as shown in the following figure, type the number of the remote node that you want to configure.

Remote Node Configuration

4-1