P782M G.SHDSL Bridge

If, after logging on, there is no activity for longer than 5 minutes, your Prestige will automatically log you out and display a blank screen. Press [ENTER] to bring up the login screen again.

2.6Resetting the Prestige

If you forget your password or cannot access the Prestige, you will need to reload the factory-default configuration file. Uploading the configuration file replaces the current configuration file with the factory- default configuration file. This means that you will lose all configurations that you had previously and the speed of the console port will be reset to the default of 9600bps with 8 data bit, no parity, one stop bit and flow control set to none. The password will be reset to “1234” and the LAN IP address to 192.168.1.1also.

To obtain the default configuration file, download it from the ZyXEL FTP site, unzip it and save it in a folder. Turn the Prestige off and then on to begin a session. When you turn on the Prestige again you will see the initial screen. When you see the message “Press any key to enter Debug Mode within 3 seconds” press any key to enter debug mode.

To upload the configuration file, do the following:

1.Type atlc after the Enter Debug Mode message.

2.Wait for the Starting XMODEM upload message before activating XMODEM upload on your terminal.

3.After a successful firmware upload, type atgo to restart the Prestige.

The Prestige is now reinitialized with a default configuration file including the default password of “1234”.

2.6.1 Methods of Restoring Factory-Defaults

You can erase the current configuration and restore factory defaults by uploading the default configuration file via the console port as described above. See later in this User’s Guide for more information on how to transfer the configuration file to your Prestige using the SMT menus.

2.7Prestige 782 SMT Menu Overview

The following figure gives you an overview of the various SMT menu screens of your Prestige.

Hardware Installation and Initial Setup