P782M G.SHDSL Bridge
3.4.1 LAN Port Filter Setup
This menu allows you to specify filter set(s) that you wish to apply to the Ethernet traffic. You seldom need to filter Ethernet traffic; however, the filter sets may be useful to block certain packets, reduce traffic and prevent security breaches.
Menu 3.1 - LAN Port Filter Setup
Input Filter Sets: device filters=
Output Filter Sets:
device filters=
Press ENTER to Confirm or ESC to Cancel:
Figure 3-3 Menu 3.1 — LAN Port Filter Setup
If you need to define filters, please read the Filter Set Configuration chapter first, then return to this menu to define the filter sets.
3.5Protocol Dependent Ethernet Setup
Depending on the protocols for your applications, you need to configure the respective Ethernet Setup, as outlined next.
For TCP/IP Ethernet setup refer to Internet Access Application.
3.6TCP/IP Ethernet Setup
This section describes how to configure the Ethernet (or LAN) using Menu 3 — TCP/IP Ethernet Setup. From the main menu, enter 3 to display the menu shown next.
Menu 3 – TCP/IP Ethernet Setup
TCP/IP Setup:
IP Address: 192.168.1.1
IP Subnet Mask: 255.255.255.0
Enter Menu Selection Number:
Figure 3-4 Menu 3 —Ethernet Setup
Internet Access |