P782M G.SHDSL Bridge

2.11.3 Transfer Rates

The Prestige supports the following symmetrical multi-rate data transmission speeds:

72, 136, 200, 264, 392, 520, 776, 1032, 1160, 1544, 1736, 2056 and 2312 Kbps.

You can increase the capacity of the Internet connection (within certain limitations) without changing your ISP or buying new equipment.

For back-to-back applications make sure that your Prestige and its peer have the same Transfer Max Rate and the same Transfer Min Rate. Two (maximum and minimum) transfer rates are used to accommodate fluctuations in line speed. This is known as Dynamic Bandwidth Allocation.

2.11.4 Standard Mode

If your Prestige is a server, then select the mode that applies to your region: ANSI (American National Standards Institute) and ETSI (European Telecommunications Standards Institute). If your Prestige is a client, select the same Standard Mode that the server side selects. ANSI and ETSI create recommendations and standards for the telecommunications industry.

Menu 2 - WAN Setup

Service Type: Client

Rate Adaption= Enable

Transfer Max Rate(Kbps)= 2312K

Transfer Min Rate(Kbps)= 72K

Standard Mode= ANSI (ANNEX_A)

Press ENTER to Confirm or ESC to Cancel:

Press Space Bar to Toggle.

 

Figure 2-9 Menu 2 — WAN Setup

 

Table 2-5 Menu 2 — WAN Setup

 

 

FIELD

DESCRIPTION

 

 

Service Type

Press [SPACE BAR] to select Server (COE) or Client (CPE).

 

 

Rate Adaption

Press [SPACE BAR] to select Enable (activate) or Disable (deactivate).

 

 

Transfer Max Rate

Press [SPACE BAR] to select a Transfer Max Rate greater than or equal to

(2312 Kbps)

the Transfer Min Rate and press [ENTER] to continue.

Transfer Min Rate

Press [SPACE BAR] to select a Transfer Min Rate less than or equal to the

(72 Kbps)

Transfer Max Rate and press [ENTER] to continue.

 

 

Standard Mode

Press [SPACE BAR] to select ANSI (ANNEX A) or ETSI (ANNEX B) and press

 

[ENTER] to continue. The Client side must match the Server side.

Hardware Installation and Initial Setup