Chapter 12 Bandwidth Control
Figure 59 Advanced Application > Bandwidth Control
The following table describes the related labels in this screen.
Table 31 Advanced Application > Bandwidth Control
LABEL | DESCRIPTION |
Active | Select this check box to enable bandwidth control on the Switch. |
|
|
Port | This field displays the port number. |
|
|
* | Settings in this row apply to all ports. |
| Use this row only if you want to make some settings the same for all ports. Use this |
| row first to set the common settings and then make adjustments on a |
| basis. |
| Note: Changes in this row are copied to all the ports as soon as you |
| make them. |
|
|
Ingress Rate |
|
|
|
Active | Select this check box to activate commit rate limits on this port. |
|
|
Commit | Specify the guaranteed bandwidth allowed in kilobits per second (Kbps) for the |
Rate | incoming traffic flow on a port. The commit rate should be less than the peak rate. The |
| sum of commit rates cannot be greater than or equal to the uplink bandwidth. |
|
|
Active | Select this check box to activate peak rate limits on this port. |
|
|
Peak | Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the incoming |
Rate | traffic flow on a port. |
|
|
Active | Select this check box to activate egress rate limits on this port. |
|
|
Egress Rate | Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the out- |
| going traffic flow on a port. |
|
|
Apply | Click Apply to save your changes to the Switch’s |
| these changes if it is turned off or loses power, so use the Save link on the top |
| navigation panel to save your changes to the |
| configuring. |
|
|
Cancel | Click Cancel to reset the fields. |
118 |
| |
| ||
|
|
|