Chapter 29 Access Control
Figure 138 Management > Access Control > SNMP
The following table describes the labels in this screen.
Table 93 Management > Access Control > SNMP
LABEL | DESCRIPTION |
General Setting | Use this section to specify the SNMP version and community (password) values. |
|
|
Version | Select the SNMP version for the Switch. The SNMP version on the Switch must |
| match the version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP |
| version 3 (v3) or both (v3v2c). |
| Note: SNMP version 2c is backwards compatible with SNMP |
| version 1. |
|
|
Get Community | Enter the Get Community string, which is the password for the incoming Get- and |
| GetNext- requests from the management station. |
| The Get Community string is only used by SNMP managers using SNMP version |
| 2c or lower. |
|
|
Set Community | Enter the Set Community, which is the password for incoming Set- requests from |
| the management station. |
| The Set Community string is only used by SNMP managers using SNMP version |
| 2c or lower. |
|
|
Trap Community | Enter the Trap Community string, which is the password sent with each trap to |
| the SNMP manager. |
| The Trap Community string is only used by SNMP managers using SNMP |
| version 2c or lower. |
|
|
Trap Destination | Use this section to configure where to send SNMP traps from the Switch. |
|
|
Version | Specify the version of the SNMP trap messages. |
|
|
IP | Enter the IP addresses of up to four managers to send your SNMP traps to. |
240 |
| |
| ||
|
|
|