|
| Chapter 7 Basic Setting |
| Table 11 Basic Setting > IP Setup (continued) | |
| LABEL | DESCRIPTION |
| IP Address | Enter the IP address of your Switch in dotted decimal notation for example |
|
| 192.168.1.1. |
|
|
|
| IP Subnet Mask | Enter the IP subnet mask of your Switch in dotted decimal notation for example |
|
| 255.255.255.0. |
|
|
|
| Default Gateway | Enter the IP address of the default outgoing gateway in dotted decimal notation, |
|
| for example 192.168.1.254. |
|
|
|
| VID | Enter the VLAN identification number associated with the Switch IP address. |
|
| This is the VLAN ID of the CPU and is used for management only. The default is |
|
| "1". All ports, by default, are fixed members of this "management VLAN" in order |
|
| to manage the device from any port. If a port is not a member of this VLAN, then |
|
| users on that port cannot access the device. To access the Switch make sure |
|
| the port that you are connected to is a member of Management VLAN. |
|
|
|
| ||
|
|
|
| IP Address | Enter the IP address of your Switch in dotted decimal notation for example |
|
| 192.168.0.1. |
|
| If you change this IP address, make sure the computer connected to this |
|
| management port is in the same subnet before accessing the Switch. |
|
|
|
| Subnet Mask | Enter the IP subnet mask of your Switch in dotted decimal notation for example |
|
| 255.255.255.0. |
|
|
|
| Default Gateway | Enter the IP address of the default outgoing gateway in dotted decimal notation, |
|
| for example 192.168.0.254. |
|
|
|
| Apply | Click Apply to save your changes to the Switch’s |
|
| loses these changes if it is turned off or loses power, so use the Save link on the |
|
| top navigation panel to save your changes to the |
|
| are done configuring. |
|
|
|
| Cancel | Click Cancel to begin configuring the fields again. |
|
|
|
|
| |
| You can create up to 64 IP addresses, which are used to access and manage the Switch from the ports | |
| belonging to the | |
|
|
|
| IP Address | Enter the IP address for managing the Switch by the members of the VLAN |
|
| specified in the VID field below. |
|
|
|
| IP Subnet Mask | Enter the IP subnet mask in dotted decimal notation. |
|
|
|
| VID | Type the VLAN group identification number. |
|
|
|
| Default Gateway | Enter the IP address of the default outgoing gateway in dotted decimal notation. |
|
|
|
| Add | Click Add to insert the entry to the summary table below and save your changes |
|
| to the Switch’s |
|
| off or loses power, so use the Save link on the top navigation panel to save your |
|
| changes to the |
|
|
|
| Cancel | Click Cancel to reset the fields to your previous configuration. |
|
|
|
| Index | This field displays the index number of the rule. Click an index number to edit |
|
| the rule. |
|
|
|
| IP Address | This field displays the IP address. |
|
|
|
| IP Subnet Mask | This field displays the subnet mask. |
|
|
|
| VID | This field displays the ID number of the VLAN group. |
|
|
|
| Default Gateway | This field displays the IP address of the default gateway. |
|
|
|
| 77 |
|
|