Chapter 23 IP Source Guard
The following table describes the labels in this screen.
Table 76 ARP Inspection VLAN Configure
LABEL | DESCRIPTION |
VLAN | Use this section to specify the VLANs you want to manage in the section |
| below. |
|
|
Start VID | Enter the lowest VLAN ID you want to manage in the section below. |
|
|
End VID | Enter the highest VLAN ID you want to manage in the section below. |
|
|
Apply | Click this to display the specified range of VLANs in the section below. |
|
|
VID | This field displays the VLAN ID of each VLAN in the range specified above. |
| If you configure the * VLAN, the settings are applied to all VLANs. |
|
|
Enabled | Select Yes to enable ARP inspection on the VLAN. Select No to disable |
| ARP inspection on the VLAN. |
|
|
Log | Specify when the Switch generates log messages for receiving ARP |
| packets from the VLAN. |
| None: The Switch does not generate any log messages when it receives |
| an ARP packet from the VLAN. |
| Deny: The Switch generates log messages when it discards an ARP |
| packet from the VLAN. |
| Permit: The Switch generates log messages when it forwards an ARP |
| packet from the VLAN. |
| All: The Switch generates log messages every time it receives an ARP |
| packet from the VLAN. |
|
|
Apply | Click Apply to save your changes to the Switch’s |
| Switch loses these changes if it is turned off or loses power, so use the |
| Save link on the top navigation panel to save your changes to the non- |
| volatile memory when you are done configuring. |
|
|
Cancel | Click this to reset the values in this screen to their |
|
|
202 |
| |
| ||
|
|
|