Chapter 15 Link Aggregation
Figure 64 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
The following table describes the labels in this screen.
Table 38 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
LABEL | DESCRIPTION | |
Link | Note: Do not configure this screen unless you want to enable | |
Aggregation | ||
dynamic link aggregation. | ||
Control | ||
Protocol |
| |
|
| |
Active | Select this checkbox to enable Link Aggregation Control Protocol (LACP). | |
|
| |
System | LACP system priority is a number between 1 and 65,535. The switch with the lowest | |
Priority | system priority (and lowest port number if system priority is the same) becomes the | |
| LACP “server”. The LACP “server” controls the operation of LACP setup. Enter a | |
| number to set the priority of an active port using Link Aggregation Control Protocol | |
| (LACP). The smaller the number, the higher the priority level. | |
|
| |
Group ID | The field identifies the link aggregation group, that is, one logical link containing | |
| multiple ports. | |
|
| |
LACP Active | Select this option to enable LACP for a trunk. | |
|
| |
Port | This field displays the port number. | |
|
|
| 127 |
|
|