Chapter 27 RIP

automatically created when you configure a new IP domain in the IP Setup screen (refer to Section 7.6 on page 71).

Figure 114 IP Application > RIP

The following table describes the labels in this screen.

Table 84 IP Application > RIP

LABEL

DESCRIPTION

Active

Select this check box to enable RIP on the Switch.

 

 

Index

This field displays the index number of an IP interface.

 

 

Network

This field displays the IP interface configured on the Switch.

 

Refer to the section on IP Setup for more information on configuring IP

 

domains.

 

 

Directio

Select the RIP direction from the drop-down list box. Choices are Outgoing,

n

Incoming, Both and None.

 

 

Version

Select the RIP version from the drop-down list box. Choices are RIP-1, RIP-

 

2B and RIP-2M.

 

 

Apply

Click Apply to save your changes to the Switch’s run-time memory. The Switch

 

loses these changes if it is turned off or loses power, so use the Save link on

 

the top navigation panel to save your changes to the non-volatile memory

 

when you are done configuring.

 

 

Cancel

Click Cancel to begin configuring this screen afresh.

 

 

240

 

GS2200-48 User’s Guide