P-660H/HW/W-T Series User’ Guide

Figure 129 Menu 11.5 Remote Node Filter (PPPoA or PPPoE Encapsulation)

Menu 11.5 - Remote Node Filter Input Filter Sets:

protocol filters= device filters= Output Filter Sets: protocol filters= device filters=

Call Filter Sets: protocol filters=

device filters=

Enter here to CONFIRM or ESC to CANCEL:

24.5 Editing ATM Layer Options

Follow the steps shown next to edit Menu 11.6 – Remote Node ATM Layer Options.

In menu 11.1, move the cursor to the Edit ATM Options field and then press [SPACE BAR] to select Yes. Press [ENTER] to display Menu 11.6 – Remote Node ATM Layer Options.

There are two versions of menu 11.6 for the Prestige, depending on whether you chose VC- based/LLC-basedmultiplexing and PPP encapsulation in menu 11.1.

24.5.1 VC-based Multiplexing (non-PPP Encapsulation)

For VC-basedmultiplexing, by prior agreement, a protocol is assigned a specific virtual circuit, for example, VC1 will carry IP. Separate VPI and VCI numbers must be specified for each protocol.

Figure 130 Menu 11.6 for VC-based Multiplexing

Menu 11.6 - Remote Node ATM Layer Options

VPI/VCI (VC-Multiplexing)

VC Options for IP:

VC Options for Bridge:

VPI #=

8

VPI #= 1

VCI #=

35

VCI #= 36

ATM QoS Type= UBR

ATM QoS Type= N/A

Peak Cell Rate (PCR)= 0

Peak Cell Rate (PCR)= N/A

Sustain Cell Rate (SCR)= 0

Sustain Cell Rate (SCR)= N/A

Maximum Burst Size (MBS)= 0

Maximum Burst Size (MBR)= N/A

Enter here to CONFIRM or ESC to CANCEL:

24.5.2 LLC-based Multiplexing or PPP Encapsulation

For LLC-basedmultiplexing or PPP encapsulation, one VC carries multiple protocols with protocol identifying information being contained in each packet header.

243

Chapter 24 Remote Node Configuration