Figure 141 Menu 4 Applying NAT for Internet Access
Menu 4 - Internet Access Setup
ISP's Name= MyISP
Encapsulation= RFC 1483
Multiplexing=
VPI #= 8
VCI #= 35
ATM QoS Type= UBR
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0
My Login= N/A
My Password= N/A
ENET ENCAP Gateway= N/A
IP Address Assignment= Static
IP Address= 0.0.0.0
Network Address Translation= SUA Only
Address Mapping Set= N/A
Press ENTER to Confirm or ESC to Cancel:
The following figure shows how you apply NAT to the remote node in menu 11.1.
1Enter 11 from the main menu.
2When menu 11 appears, as shown in the following figure, type the number of the remote node that you want to configure.
3Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes and then press [ENTER] to bring up Menu 11.3 - Remote Node Network Layer Options.
Figure 142 Applying NAT in Menus 4 & 11.3
Menu 11.3 - Remote Node Network Layer Options
IP Options: | Bridge Options: |
IP Address Assignment = Static | Ethernet Addr Timeout(min)= N/A |
Rem IP Addr = 0.0.0.0 |
|
Rem Subnet Mask= 0.0.0.0 |
|
My WAN Addr= 0.0.0.0 |
|
NAT= SUA Only |
|
Address Mapping Set= N/A |
|
Metric= 2 |
|
Private= No |
|
RIP Direction= Both |
|
Version= |
|
Multicast= None |
|
IP Policies= |
|
Enter here to CONFIRM or ESC to CANCEL:
The following table describes the options for Network Address Translation.
255 | Chapter 27 Network Address Translation (NAT) |