P-660H/HW/W-T Series User’ Guide

Figure 202 Telnet Into Menu 24.7.2 System Maintenance

Menu 24.7.2 - System Maintenance - Upload System Configuration File

To upload the system configuration file, follow the procedure below:

1.Launch the FTP client on your workstation.

2.Type "open" and the IP address of your system. Then type "root" and SMT password as requested.

3.Type "put configuration filename rom-0" where "configurationfilename" is the name of your system configuration file on your workstation, which will be transferred to the "rom-0" file on the system.

4.The system reboots automatically after the upload system configuration file process is complete.

For details on FTP commands, please consult the documentation of your FTP client program. For details on uploading system firmware using TFTP (note that you must remain on this menu to upload system firmware using TFTP), please see your manual.

Press ENTER to Exit:

To upload the firmware and the configuration file, follow these examples

33.4.3 FTP File Upload Command from the DOS Prompt Example

1Launch the FTP client on your computer.

2Enter “open”, followed by a space and the IP address of your Prestige.

3Press [ENTER] when prompted for a username.

4Enter your password as requested (the default is “1234”).

5Enter “bin” to set transfer mode to binary.

6Use “put” to transfer files from the computer to the Prestige, for example, “put firmware.bin ras” transfers the firmware on your computer (firmware.bin) to the Prestige and renames it “ras”. Similarly, “put config.rom rom-0” transfers the configuration file on your computer (config.rom) to the Prestige and renames it “rom-0”. Likewise “get rom-0 config.rom” transfers the configuration file on the Prestige to your computer and renames it “config.rom.” See earlier in this chapter for more information on filename conventions.

7Enter “quit” to exit the ftp prompt.

The Prestige automatically restarts after a successful file upload.

Chapter 33 Firmware and Configuration File Maintenance

314