P-660H/HW/W-T Series User’ Guide

Table 111 General Commands for GUI-based TFTP Clients

COMMAND

DESCRIPTION

 

 

Host

Enter the IP address of the Prestige. 192.168.1.1 is the Prestige’s default IP address

 

when shipped.

Send/Fetch

Use “Send” to upload the file to the Prestige and “Fetch” to back up the file on your

 

computer.

Local File

Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom

 

extension) on your computer.

Remote File

This is the filename on the Prestige. The filename for the firmware is “ras” and for the

 

configuration file, is “rom-0”.

Binary

Transfer the file in binary mode.

 

 

Abort

Stop transfer of the file.

 

 

Refer to Section 33.2.5 on page 309 to read about configurations that disallow TFTP and FTP over WAN.

33.3 Restore Configuration

This section shows you how to restore a previously saved configuration. Note that this function erases the current configuration before restoring a previous back up configuration; please do not attempt to restore unless you have a backup configuration file stored on disk.

FTP is the preferred method for restoring your current computer configuration to your Prestige since FTP is faster. Please note that you must wait for the system to automatically restart after the file transfer is complete.

Note: Do not interrupt the file transfer process as this may PERMANENTLY DAMAGE YOUR Prestige.

33.3.1 Restore Using FTP

For details about backup using (T)FTP please refer to earlier sections on FTP and TFTP file upload in this chapter.

311

Chapter 33 Firmware and Configuration File Maintenance