ZyXEL |
How to access the Command Line Interface (CLI)?
There are two ways to access the Command Line Interface: through the console port or Telnet.
If you want to access through the console port, Refer to the “How to access the Switch through the console port?” section for more information.
If I have forgotten the password, how to reset the password to the default setting?
If you have changed and forgotten the password, you will need to reload the factory default configuration. Note that all your previous configuration will be lost.
1.Connect the console cable to your computer and launch a terminal emulation software.
2.Restart the switch, and press any key to enter the debug mode at the “Press any key to enter Debug Mode within 3 seconds” prompt.
3.Enter “atlc”.
4.When the “starting XMODEM upload” message displays, start XMODEM upload of the default configuration (rom) file to the switch.
5.After the file upload process is complete, enter “atgo” to exit from the debug mode.
6.The system will automatically restart. Wait until the system has restarted before you log in again. The default IP address is 192.168.1.1 and the default password is 1234.
How to configure the IP address?
All contents copyright 2008 ZyXEL Communications Corporation. | 115 |
