ZyAIR Wireless Gateway Series User’s Guide

Table 21-2 Menu 11.3 Remote Node Network Layer Options

FIELD

DESCRIPTION

EXAMPLE

 

 

 

Network

Press [SPACE BAR] and then [ENTER] to select Full Feature if you

Full

Address

have multiple public WAN IP addresses for your ZyAIR.

Feature

Translation

Select SUA Only if you have just one public WAN IP address for your

 

 

 

 

ZyAIR. The SMT uses Address Mapping Set 255 (menu 15.1 - see

 

 

section 23.2.1).

 

 

Select None to disable NAT.

 

 

 

 

Metric

The metric represents the “cost” of transmission for routing purposes.

2

 

IP routing uses hop count as the cost measurement, with a minimum of

 

 

1 for directly connected networks. Type a number that approximates the

 

 

cost for this link. The number need not be precise, but it must be

 

 

between 1 and 15. In practice, 2 or 3 is usually a good number.

 

 

 

 

Private

This determines if the ZyAIR will include the route to this remote node

No

 

in its RIP broadcasts. If set to Yes, this route is kept private and not

 

 

included in RIP broadcast. If No, the route to this remote node will be

 

 

propagated to other hosts through RIP broadcasts.

 

 

 

 

RIP Direction

Press [SPACE BAR] and then [ENTER] to select the RIP Direction.

None

 

Options are Both, In Only, Out Only or None.

 

Version

Press [SPACE BAR] and then [ENTER] to select the RIP version.

RIP-1

 

Options are RIP-1, RIP-2Bor RIP-2M.

 

Multicast

IGMP-v1sets IGMP to version 1, IGMP-v2sets IGMP to version 2 and

None

 

None disables IGMP.

 

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.

21.2 Remote Node Filter

Move the cursor to the Edit Filter Sets field in menu 11.1, then press [SPACE BAR] to select Yes. Press [ENTER] to display Menu 11.5 - Remote Node Filter.

Use Menu 11.5 - Remote Node Filter to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote node and the ZyAIR and also to prevent certain packets from triggering calls. You can specify up to 4 filter sets separated by comma, for example, 1, 5, 9, 12, in each filter field.

Note that spaces are accepted in this field.

21-6

Remote Node Configuration