ZyXEL Communications Wireless Gateway Series 21.2.1 IP Static Route Setup, Figure 21-3Menu 11.5 Remote Node Filter (Ethernet Encapsulation )

ZyAIR Wireless Gateway Series User’s Guide

Menu 11.5 - Remote Node Filter

Input Filter Sets: protocol filters= 1, 2, 3

device filters= Output Filter Sets: protocol filters= device filters=

Enter here to CONFIRM or ESC to CANCEL:

Figure 21-3 Menu 11.5 Remote Node Filter (Ethernet Encapsulation )

Menu 11.5 - Remote Node Filter

Input Filter Sets: protocol filters= device filters= Output Filter Sets:

protocol filters= 1

device filters= Call Filter Sets: protocol filters= device filters=

Enter here to CONFIRM or ESC to CANCEL:

Figure 21-4 Menu 11.5 Remote Node Filter (PPTP or PPPoE Encapsulation)

21.2.1 IP Static Route Setup

Static routes tell the ZyAIR routing information that it cannot learn automatically through other means. This can arise in cases where RIP is disabled on the LAN or a remote network is beyond the one that is directly connected to a remote node.

Each remote node specifies only the network to which the gateway is directly connected and the ZyAIR has no knowledge of the networks beyond. For instance, the ZyAIR knows about network N2 in the following figure through remote node Router 1. However, the ZyAIR is unable to route a packet to network N3 because it does not know that there is a route through remote node Router 1 (via Router 2). The static routes allow you to tell the ZyAIR about the networks beyond the remote nodes.

Remote Node Configuration 21-7