Chapter 4 Wizard Setup

Figure 38 VPN Advanced Wizard: Step 2

The following table describes the labels in this screen.

Table 18 VPN Advanced Wizard: Step 2

LABEL

DESCRIPTION

Remote

 

Gateway

 

 

 

Name

Type the name used to identify this VPN connection (and VPN gateway). You may

 

use 1-31 alphanumeric characters, underscores(_), or dashes (-), but the first

 

character cannot be a number. This value is case-sensitive.

Secure

Enter the WAN IP address or domain name of the remote IPSec router (secure

Gateway

gateway) in the field below to identify the remote IPSec router by its IP address or a

 

domain name. Set this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN

 

IP address.

 

 

My Address

Select an interface from the drop-down list box to use on your ZyWALL.

(interface)

 

 

 

Authentication

 

Method

 

 

 

Pre-Shared

Type your pre-shared key in this field. A pre-shared key identifies a communicating

Key

party during a phase 1 IKE negotiation. It is called "pre-shared" because you have to

 

share it with another party before you can communicate with them over a secure

 

connection.

 

Type from 8 to 31 case-sensitive ASCII characters or from 16 to 62 hexadecimal ("0-

 

9", "A-F") characters. Precede hexadecimal characters with “0x”.

 

Both ends of the VPN tunnel must use the same pre-shared key. You will receive a

 

PYLD_MALFORMED (payload malformed) packet if the same pre-shared key is not

 

used on both ends.

 

 

102

 

ZyWALL USG 300 User’s Guide