Chapter 33 Device HA

Table 152 Device HA > VRRP Group (continued)

LABEL

DESCRIPTION

Apply

Click Apply to save your changes back to the ZyWALL.

 

 

Reset

Click Reset to begin configuring this screen afresh.

 

 

33.5 VRRP Group Add/Edit

The VRRP Group Add/Edit screen allows you to add VRRP groups to the ZyWALL or to edit the configuration of an existing VRRP group.

•You can only use interfaces that have static IP addresses. In addition, you should set the static IP address to the IP address of the virtual router.

•You can only enable one VRRP group for each interface.

•You can only have one active VRRP group for each virtual router (VR ID).

To access this screen, go to the VRRP Group summary screen (see Section 33.4 on page 496), and click either the Add icon or an Edit icon.

Figure 367 Device HA > VRRP Group > Edit

The following table describes the labels in this screen.

Table 153 Device HA > VRRP Group > Edit

LABEL

DESCRIPTION

Enable

Select this to make the specified interface part of the virtual router. Clear this to

 

take the specified interface out of the virtual router.

 

 

Name

This field is read-only if you are editing the VRRP group. Type the name of the

 

VRRP group. This field must be unique in the ZyWALL, but it is not used in the

 

virtual router. The virtual router uses the VRID. The name can consist of

 

alphanumeric characters, the underscore, and the dash and may be up to fifteen

 

characters long.

 

 

498

 

ZyWALL USG 300 User’s Guide