Chapter 12 Policy and Static Routes
Figure 149 Network > Routing > Policy Route
The following table describes the labels in this screen.
Table 66 Network > Routing > Policy Route
LABEL | DESCRIPTION |
Enable BWM | This is a global setting for enabling or disabling bandwidth management on the |
| ZyWALL. You must enable this setting to have individual policy routes or application |
| patrol policies apply bandwidth management. |
| This same setting also appears in the AppPatrol > General screen. Enabling or |
| disabling it in one screen also enables or disables it in the other screen. |
|
|
# | This is the number of an individual policy route. |
|
|
User | This is the name of the user (group) object from which the packets are sent. any |
| means all users. |
|
|
Schedule | This is the name of the schedule object. none means the route is active at all times |
| if enabled. |
|
|
Incoming | This is the interface on which the packets are received. |
|
|
Source | This is the name of the source IP address (group) object. any means all IP |
| addresses. |
|
|
Destination | This is the name of the destination IP address (group) object. any means all IP |
| addresses. |
|
|
Service | This is the name of the service object. any means all services. |
|
|
This is the next hop to which packets are directed. It helps forward packets to their | |
| destinations and can be a router, VPN tunnel, outgoing interface or trunk. |
|
|
SNAT | This is the source IP address that the route uses. |
| It displays none if the ZyWALL does not perform NAT for this route. |
|
|
BWM | This is the maximum bandwidth allotted to the policy. 0 means there is no bandwidth |
| limitation for this route. |
|
|
228 |
| |
ZyWALL USG 300 User’s Guide |
| |
|
|
|