Chapter 30 ADP

The following table describes the screens in this screen.

Table 139 Anti-X > ADP > General

LABEL

DESCRIPTION

General Setup

 

 

 

Enable Anomaly

Select this check box to enable traffic anomaly and protocol anomaly

Detection

detection.

 

 

Bindings

Use this list to specify which anomaly profile the ZyWALL uses for traffic

 

flowing in a specific direction.

 

 

Priority

This is this binding’s rank in the list of anomaly profile to traffic direction

 

bindings. The list is applied in order of priority.

 

 

From, To

This is the direction of travel of packets to which an anomaly profile is bound.

 

Note: Depending on your network topology and traffic load,

 

binding every packet direction to an anomaly profile may

 

affect the ZyWALL’s performance.

 

From LAN To LAN means packets traveling from a computer on one LAN

 

subnet to a computer on another LAN subnet via the ZyWALL’s LAN zone

 

interfaces. The ZyWALL does not check packets traveling from a LAN

 

computer to another LAN computer on the same subnet.

 

From WAN To WAN means packets that come in from the WAN zone and

 

the ZyWALL routes back out through the WAN zone.

 

 

Anomaly Profile

An anomaly profile is a set of anomaly rules with configured activation, log

 

and action settings. This field shows which anomaly profile is bound to which

 

traffic direction.

 

 

(Icons)

Click the Add icon in the heading row to add a new first entry.

 

The Active icon displays whether the entry is enabled or not. Click it to

 

activate or deactivate the entry. Make sure you click Apply to save and apply

 

the change.

 

Click the Edit icon to go to the screen where you can edit the entry.

 

Click the Add icon in an entry to add an entry below the current entry.

 

Click the Remove icon to delete an existing entry from the ZyWALL. A

 

window displays asking you to confirm that you want to delete the entry. Note

 

that subsequent entries move up by one when you take this action.

 

In a numbered list, click the Move to N icon to display a field to type an index

 

number for where you want to put that entry and press [ENTER] to move the

 

entry to the number that you typed. For example, if you type 6, the entry you

 

are moving becomes number 6 and the previous entry 6 (if there is one) gets

 

pushed up (or down) one.

 

The ordering of your entries is important as they are applied in order of their

 

numbering.

 

 

Apply

Click Apply to save your changes.

 

 

Reset

Click Reset to start configuring this screen again.

30.4 Configuring Anomaly Profile Bindings

Click Anti-X > ADP > General and then an Add or Edit icon to display the following screen. Use this screen to bind an anomaly profile to a traffic direction.

 

447

ZyWALL USG 300 User’s Guide