Chapter 10 Interface

Figure 141 Network > Interface > Auxiliary

Each field is described in the table below.

Table 61 Network > Interface > Auxiliary

LABEL

DESCRIPTION

Auxiliary Interface

 

Properties

 

 

 

Enable

Select this to turn on the auxiliary dial up interface. The interface does not dial

 

out, however, unless it is part of a trunk and load-balancing conditions are

 

satisfied.

 

 

Description

Enter a description of this interface. It is not used elsewhere. You can use

 

alphanumeric and ()+/:=?!*#@$_%- characters, and it can be up to 60

 

characters long.

Port Speed

Select the speed of the connection between the ZyWALL and external

 

computer.

 

 

Dialing Type

Tone - select this if the telephone uses tone-based dialing.

 

Pulse - select this if the telephone uses pulse-based dialing.

 

 

Initial String

Enter the AT command string to initialize the external modem. ATZ is the most

 

common string, but you should check the manual for the external modem for

 

additional commands.

 

 

Auxiliary

 

Configuration

 

 

 

Phone Number

Enter the phone number to dial here. You can use 1-20 numbers, commas (,),

 

or plus signs (+). Use a comma to pause during dialing. Use a plus sign to tell

 

the external modem to make an international call.

 

 

User Name

Enter the user name required for authentication.

 

 

Password

Enter the password required for authentication.

 

 

Retype to

Enter the password again to make sure you have not typed it incorrectly.

confirm

 

 

 

216

 

ZyWALL USG 300 User’s Guide