Husqvarna 15V2 manual Lever for adjustment of cutting height, Seat, Fuelling

Page 16

PRESENTATION

Lever for adjustment of cutting height

With this lever the cutting height can be adjusted to 9 different positions.

Unit with side or rear ejection	40-90 mm
	(1 9/16" - 3 9/16")
BioClip or Combi unit,	45-95 mm
	(1 3/4" - 3 3/4")

Seat

The seat has a jointed attachment on the front edge and can be tipped forward.

The seat can also be adjusted lengthways.

Move the lever, mounted under the frontedge of the seat, to the left. The seat can then be moved forwards or backwards to the required position.

Fuelling

The engine should be run on 87 octane (or higher) unleaded petrol/gasoline (no oil added). For more information about methanol and ethanol fuels, see “Technical Data”.

Do not fill the tank completely, leave an expansion area of at least 2.5 cm (1").

WARNING!

Petrol/gasoline is highly inflammable. Observe care and fill up with fuel outdoors (see safety instructions).

IMPORTANT INFORMATION

The air intake grille in the engine cover behind the driver’s seat must not be blocked by, for example, clothing, leaves, grass or dirt.

Impaired cooling of the engine. Risk of major engine damage.

14 – English

Image 16

Contents Rider EnglishSvenska Contents Introduction Dear customerTravel and transport on public roads TowingGood service Serial numberExplanation of Symbols Safety Instructions General useKeep children away from the area to be mowed Driving on slopes Proceed as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Throttle control Choke leverSpeed limiter Parking brakeCutting unit Lift lever for cutting unitSeat Lever for adjustment of cutting heightFuelling Before starting DrivingStarting the engine Driving Driving the machine Cutting tips Stopping the engine Release leverMaintenance Maintenance scheduleDaily Maintenance interval Hours Before start 100 200Removing the machine hoods Engine hoodFront hood Right-hand fenderAdjusting the brake Checking and adjustment of the steering wiresPoorly adjusted brakes can result in reduced braking power Checking and adjusting the choke wire Checking and adjustment of the throttle wireReplacing the fuel filter Replacing the air filter VarningChecking of the fuel pump’s air filter Check the level of the battery acidFitting the wrong spark plug type can damage the engine Inspecting the safety system Checking the tyre pressure Main fuseChecking the engine’s cooling air intake Fitting the cutting unit Observe caution to avoid trapping your handInstalling BioClip Removing the cutting unitChecking and adjusting the cutting unit’s ground pressure Adjusting the parallelism of the cutting unit Belt replacement on BioClipChecking the cutting unit’s parallelism Replacing the cutting unit beltBelt change on Combi Maintenance Service position for the cutting unit Placing in service positionMaintenance Restoring from service position Checking the blades Replacing the break-pin BioClip 90, Combi Removal of BioClip plug CombiLubrication Checking the engine’s oil levelChanging the oil Changing the oil filterChecking the transmission’s oil level Lubricating the belt adjusterGeneral lubrication Trouble Shooting Schedule Problem ProcedureService StorageWinter storage CoverTechnical Data EU declaration of conformity Only applies to Europe Pre-delivery service Service JournalWork done Work done Date, mileage, stamp, sign ´z+H-¶6-¨ English 114 01