Husqvarna 15V2 manual EU declaration of conformity Only applies to Europe

Page 47

EU declaration of conformity (Only applies to Europe)

Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declares under sole responsibility that the Husqvarna Rider 15V2, from 2002’s serial numbers and onwards (the year is clearly stated in plain text on the rating plate with subsequent serial number), complies with the requirements of the COUNCIL’S DIRECTIVES:

-of June 22, 1998 ”relating to machinery” 98/37/EC, annex IIA.

-of May 3, 1989 ”relating to electromagnetic compatibility” 89/336/EEC, and applicable supplements.

-of May 8, 2000 ”relating to the emission of noise to surroundings” 2000/14/EC.

Information regarding noise emissions and the mowing width, see the Technical Data.

The following harmonised standards have been applied: EN292-2, EN836.

The registered body 0404, SMP Svensk Maskinprovning AB, Fyrisborgsgatan 3, SE-754 50 Uppsala, Sweden has issued the report with number 01/901/019, 01/901/020 regarding the assessment of conformity according to annex VI to the COUNCIL’S DIRECTIVE of May 8, 2000 ”relating to the emission of noise to surroundings” 2000/14/EC.

Huskvarna January 3, 2002

Roger Andersson, Development Manager/Garden Products

When this product is worn out or no longer used it should be returned to the dealer or other appropriate body for recycling.

We reserve the right to change technical specifications without prior notice.

Note that no legal claims are valid on the basis of information in this manual.

Use only genuine parts for repairs. The warranty is not valid if non genuine parts are used.

English – 45

Image 47

Contents English RiderSvenska Contents Towing IntroductionDear customer Travel and transport on public roadsSerial number Good serviceExplanation of Symbols General use Safety InstructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Location of the controls PresentationPresentation Parking brake Throttle controlChoke lever Speed limiterLift lever for cutting unit Cutting unitFuelling Lever for adjustment of cutting heightSeat Starting the engine DrivingBefore starting Driving Driving the machine Cutting tips Release lever Stopping the engineHours Before start 100 200 MaintenanceMaintenance schedule Daily Maintenance intervalRight-hand fender Removing the machine hoodsEngine hood Front hoodPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake Replacing the fuel filter Checking and adjustment of the throttle wireChecking and adjusting the choke wire Varning Replacing the air filterFitting the wrong spark plug type can damage the engine Check the level of the battery acidChecking of the fuel pump’s air filter Inspecting the safety system Checking the engine’s cooling air intake Main fuseChecking the tyre pressure Observe caution to avoid trapping your hand Fitting the cutting unitRemoving the cutting unit Installing BioClipChecking and adjusting the cutting unit’s ground pressure Replacing the cutting unit belt Adjusting the parallelism of the cutting unitBelt replacement on BioClip Checking the cutting unit’s parallelismBelt change on Combi Maintenance Placing in service position Service position for the cutting unitMaintenance Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClip 90, CombiChecking the engine’s oil level LubricationChanging the oil filter Changing the oilGeneral lubrication Lubricating the belt adjusterChecking the transmission’s oil level Problem Procedure Trouble Shooting ScheduleCover ServiceStorage Winter storageTechnical Data EU declaration of conformity Only applies to Europe Work done Service JournalPre-delivery service Work done Date, mileage, stamp, sign ´z+H-¶6-¨ English 114 01